# Whatnot card break setup for sports and football cards > An overhead rip camera, a sorting system for hits per buyer and Large Letter packing, for running football and sports card breaks on Whatnot and eBay. - Built for: You run football and other sports card breaks on Whatnot, sell singles from them on eBay, and post 20 to 80 small orders a week from a desk. - Platforms: Whatnot, eBay - Orders a week: 20–80 - Space: Corner of a room - Kit total: £246 to £408 - Running cost: £93 to £150 (Consumables at 50 orders a week) - Updated 6 October 2026 In a break, every card from the box goes to the buyer who owns that team or slot. Viewers watch the rip from above, so spend on the overhead camera and even light before anything on the back wall. Off camera, you sleeve each hit, sort it to its owner and post it in one envelope with that buyer’s other cards. With a team bag per buyer during the show, most of the post is done when you stop filming. ## The kit - **[Overhead phone arm](https://sellersetups.com/product/overhead-phone-arm)** (£20 to £35): Card and small-item shows sell on the shot of your hands. An overhead arm holds the phone steady and out of your way while you open packs. - **[Two LED video panels with stands](https://sellersetups.com/product/led-panel-pair)** (£45 to £75): Holo cards, foiled boxes and glossy packaging reflect a ring light straight back at the camera. With two panels angled in from each side, the glare falls outside the frame. - **[Clip-on wireless phone mic](https://sellersetups.com/product/wireless-phone-mic)** (£25 to £45): Viewers leave a show when they can't hear you. A clip-on mic keeps your voice level while you reach for stock. - **[Gooseneck phone holder](https://sellersetups.com/product/gooseneck-phone-holder)** (£12 to £20): Bends to any angle for an overhead or side shot. It wobbles more than a jointed arm when you bump the desk, so it suits short shows and listing photos. - **[Phomemo thermal label printer](https://sellersetups.com/product/phomemo-thermal-printer)** (£70 to £110): Costs less than most thermal printers and fits on a shelf. It prints the same 100 x 150 mm labels, so your label stock carries over if you upgrade later. - **[100 x 150 mm thermal labels, 250 roll](https://sellersetups.com/product/thermal-labels-roll)** (£8 to £13): Put a roll on a holder or inside a printer with a roll bay to save space on a crowded desk. Each label costs about 3p to 5p, a little more than fanfold. - **[500 g precision pocket scale](https://sellersetups.com/product/pocket-scale-500g)** (£8 to £14): Card orders often sit within a few grams of a Royal Mail weight limit. A precise small scale tells you whether a mailer goes as a Large Letter or a parcel. - **[Penny sleeves, 1,000 pack](https://sellersetups.com/product/penny-sleeves)** (£6 to £10): Stops surface scratches before the card goes into a toploader. At this pack size each sleeve costs well under a penny. - ×2 **[35pt toploaders, 100 pack](https://sellersetups.com/product/toploaders)** (£12 to £18): Buyers on Whatnot and eBay expect any card worth more than a few pounds to arrive sleeved and top-loaded. A bent card means a refund. - ×2 **[Resealable team bags, 100 pack](https://sellersetups.com/product/team-bags)** (£4 to £7): A team bag over the toploader holds the card in place and keeps moisture out, for a few pence a card. - **[Board-backed card mailers, C6, 100 pack](https://sellersetups.com/product/rigid-card-mailers)** (£10 to £18): A sleeved and top-loaded card in a rigid mailer stays flat through sorting machines and usually ships as a Large Letter, which costs far less than a parcel. - **[3,200-count card storage boxes](https://sellersetups.com/product/card-storage-boxes)** (£10 to £18): Sort singles by set and number with dividers, and you can pull a sold card without flicking through binders. ## How to lay it out ### Rip zone under the arm Clamp the overhead arm so the phone looks straight down at a plain mat in the centre of the desk. Open packs only inside that area, so viewers see every card come out. ### Second phone for chat and the board Put the gooseneck holder at the side with a second phone showing the team list and chat. You read who owns which team without leaning over the rip camera. ### Sorting rail of team bags Line up one team bag per buyer along the back edge, each with their username written on a sticky label. Move each hit from the mat into a sleeve, a toploader and its owner’s bag. ### Post tray on the left Keep rigid mailers, the pocket scale and printer at the left end. After the show you work along the rail: one bag, one mailer, one label. ## Before the break starts Print or write the team list and lay out one labelled team bag per buyer. Count the boxes or packs on camera before you open them. Keep sleeves, toploaders and a pen within reach on your right. Run the rip camera for a minute beforehand to check that holo and chrome cards don’t flare under the panels. ## Sorting hits during the rip Open each pack in the centre of the mat and fan the cards so the camera reads them. Call the team and player, then move the card to its owner’s bag before opening the next pack. Numbered cards, autographs and patches go into a penny sleeve and toploader on camera. Buyers see the hit protected straight away, and you avoid a corner ding between the mat and the bag. ## Labelling per buyer Each team bag carries the buyer’s username and the show date. After the show, match every bag to an order before printing labels, and set aside any buyer who bought into more than one break. A buyer with spots in two breaks gets one parcel. Combine their bags, then print a single label so you pay for one envelope. ## Packing for Large Letter Slide the team bag into a board-backed mailer, close it and weigh it on the pocket scale. Most single-buyer orders stay thin and light enough for Large Letter. Thick orders with many toploaders can push past the thickness limit. Check Royal Mail’s current size guide and move those to a small parcel rather than forcing the envelope shut. ## Storing sealed product and spares Keep sealed boxes for upcoming breaks on a shelf away from the desk, listed in the order you’ll open them. Spare cards from your own stock go into storage boxes divided by sport and team. Those boxes become your eBay singles stock. Note the box and divider on each listing so a sale takes a minute to pick. ## Running more breaks a week Past 50 orders, the evening after a break turns into hours of labels. A faster printer and a packing table away from the break desk keep the two jobs apart. Order toploaders and team bags in bulk once you know your weekly count. If you run out of team bags mid-show, the sorting system stops working. ## Common mistakes - Dropping hits into one pile to sort later leads to cards sent to the wrong buyer, so bag each card to its owner as it’s read out. - Posting a buyer’s two breaks in two envelopes doubles your postage, so combine their bags before printing labels. - Forcing a fat stack of toploaders into a Large Letter envelope risks a surcharge, so measure thick orders and send them as parcels. - Filming the rip at an angle hides card fronts, so set the overhead arm straight down over the mat. - Mixing your own spare singles with buyers’ cards risks listing a card you don’t own, so keep spares in a separate storage box. ## When to upgrade At about 50 orders a week, a fanfold thermal printer prints a night’s labels in one batch. At 80, a separate folding table for packing lets the break desk stay set up between shows. - 50+ orders a week: **[MUNBYN thermal label printer](https://sellersetups.com/product/munbyn-thermal-printer)** (£55 to £85): It takes the standard 100 x 150 mm labels that eBay, Vinted and Whatnot all generate, and generic labels work, so the running cost stays low. - 80+ orders a week: **[180 cm folding table](https://sellersetups.com/product/folding-work-table)** (£40 to £65): Packing on the bed or the kitchen table means setting up and clearing down every session. A table that stays up lets you leave your supplies where you need them. ## Questions ### What do I need to run card breaks on Whatnot? An overhead camera so viewers see every pack opened, steady light, a clear team or slot list and a way to keep each buyer’s cards apart. Check Whatnot’s current breaks guidance before your first one. ### How do I keep track of which cards belong to which buyer? Write the list before the show and label a team bag per buyer with their username. Put each card in its owner’s bag the moment you read it out, not into a general pile. ### Do base cards need toploaders, or only the hits? Sleeve the base cards and stack them in the buyer’s team bag. Hits, numbered cards and autographs get a penny sleeve and a toploader each. ### Can a break order go as a Large Letter? A few toploaded cards in a rigid mailer usually fit Royal Mail’s Large Letter size. Weigh and measure the thicker orders, and check the current Large Letter limits before you post. ### Should I post break cards straight away or hold them? Some breakers post after each show, others combine a buyer’s cards over a week. Say which you do in your show description so buyers know when to expect the post. ### Is the second phone necessary? You can work from one, but the overhead phone faces the mat. A second screen at eye level shows chat and the team list while you open packs. ### How do I sell leftover cards on eBay after a break? Sort spare cards from your own stock into storage boxes by sport and team, then list them on eBay as singles or lots. Keep them apart from buyers’ cards so you don’t list one by mistake.